Lease this WebApp and get rid of the ads.
Harry
FUNAI - SYMPHONIC
Thu Dec 18, 2003 3:34pm
24.235.161.123


Symphonic
Model:TVCR13B1C
Chassis:
Dead.
Replaced open C32 (100UF 160V), also check C09 (4.7UF 160V).

Symphonic
Model:TVCR19E1
Chassis:
ntermittent dead
c604 33uf 10volt capacitor in p/s

Funai
TVK199K
BLUE SCREEN CAN SEE SOME VIDEO
REPLACED R533 15K OHM 1/2 WATT
Comments:TV SOLD WITH BRAND NAME SYLVANIA

Symphonic
Model:SRT2027
Chassis:
DEAD . POSSIBLE STORM DAMAGE
FH602 (4-AMP),&GP641 ( FUNI-G31D)

Funai
Model:SC3919/F3819
Chassis:
No OSD
Replace Q309
Comments:Check for horiz pulses at IC201-58. If missing replace Q309

Symphonic
Model: WF-13
Chassis:
Will turn on but goes back off.
IHVT.
Comments:Can hear a hissing sound and can feel heat coming from under flyback with board on it's end.

Symphonic
Model:TVCR19E1
Chassis:
Dead, may be intermittent
C631 220uF at 16V & 7806 6 volt regulator
Comments:Have found this cap increased twice in last month, best to replace 7806 & 7805 too.

Symphonic
Model:TVVCR13B1
Chassis:
dead
C1025 470uf @ 10V
Comments:cap is near swichmode trasformer flyback side outside edge (left side) 1 cap in

Symphonic
Model:TVCR13B1
Chassis:
Dead
Change C1026 470 uf 10 volts in pin 14 of switch tranformer

Funai
Model:FTR13T
Chassis:
Dead
Change C1026 470uf 10 volts it is in pin 14 of switch tranforer

Symphonic
Model: WF-1901
Chassis:
Picture gets darker and darker.
Bad flyback part # LTF00CPXB021.
Comments:Fax Funai at 1-800-409-9345 for $10.50 part. Give shipping address and credit card #.(credit cards only).

Symphonic
Model:SC3809
Chassis:n/a
dead power only at C610 and collector of Q1601 no osc
C1622 47uf @16V
Comments:only electrolitic in timming smps 9" AC-DC TV-VCR combo

Symphonic
Model:tvcr 19ef
Chassis:
Dead
Shorted D612 and leaky Q604

Symphonic
Model:WF-13
Chassis:
Shuts down B+145V too high
Q672(2SA1175),Q652(2SC2785) and IC601 PF5001(optp)
Comments:Shuts down in a minute,B+ 145V too high.

Symphonic
Model: SC3913
Chassis:
Erratic operation. Eats tapes.
Dirty Mode Switch.
Comments:Clean with eraser works good.

Funai
Model:SRT2227S
Chassis:N/A
Dead /Raw B+ OK no volt. from Sw. Supply
Replace open R602 or R603 3.3 Meg Ohm 1/8 Watt
Comments:Sold with Sylvania brand name

Symphonic
Model:13tvcr
Chassis:N/A
LOADING PROBLEM...TV OK
REPLACE IC402 (BA6219)

Symphonic
Model:TVCR9E1
Chassis: Mfg 11-95
TV plays OK, except when tape installed, then shuts down.
IC651 (KIA7806P1) Regulator IC
Observation of the Video Drum shows that the drum rotation was very erratic. It would rotate very slow, or not at all. When this happens, the tape would be pulled off of the tape guides and the TV would shut down. If a "Test Cassette" is used and the set is turned on several times, it will finally stay on, with the cassette installed.

Funai
Model:SYLVANIA--SRT2019
Chassis:funi
dead
ic 601, photocoupler ic
Comments:everything checked good including this but it only developed 15 volts b+

Symphonic
Model:TVCR13E1
Chassis:
Dead or erratic functions.
C631in p/s. 220uf 16v.
Comments:On 6v Reg input.

Funai
Model:TVCR19F
Chassis:
No Video, just Blue screen with OSD, no Video Head Rotation, Tuner wont stop on channels.
Resoldered IC 651+ 652, 5 Volt Regulators, and Replaced Q651 2SD1207 going to IC652.

Symphonic
Model:TVCR19G1
Chassis:
No power or panel control, drum runs.
6V regulator IC 670 bad
Comments:Located on main board in front of tuner. P/N 7806

Symphonic
Model:WF-13
Chassis:
Shuts down at power up
D652, D667, Q672












    • FunaiHarry, Mon Sep 6 11:15am
      Funai TV FTV13TE (same as Symphonic ST131E Sams 3727) Complaint: Shuts off after a few minutes The 135V line measured 150V. Q601 and Q602 in the 135V regulator circuit were shorted. Q601 (P/N... more
  • Click here to receive daily updates