Dremel
Tue Feb 21, 2017 1:30pm
2601:642:100:eb25:558c:6b91:e2ce:dc4a

I just used a Dremel successfully to route a new groove. The trick is to take really shallow cuts, at least untill you have the groove well established, and then advance the bit depth about ⅛-3/16 of an inch at a time. Go slow.

  • Re: Cutting a new groove in a cane seat The Wicker Woman®--Cathryn, Mon Feb 20 11:20pm
    Darlene, Could you please sign your name and state in a signature file after your post? It makes replying to your messages so much easier. Please consider following the directions on the homepage for ... more
    • Dremel Kit, Tue Feb 21 1:30pm
      • Dremel DKR.SeatCaning, Tue Feb 21 2:21pm
        Thanks, Kit, for your reply. I spent a couple days strategizing, and thought that using a Dremel would work. A regular router base was too wide, and the rotary tool that I have has a router base... more
        • routing a chair seat JIm Widess, Wed Feb 22 11:20am
          So Kit, what Dremel bur would you use to cut the groove? jim@caning.com
          • Re: routing a chair seat Kit, Sat Feb 25 12:30pm
            Hi Jim, This is what I ordered from Amazon as what was in the Dremel kit didn't work. I used the largest bit. It worked for me as it was a narrow groove that I needed on a back.... more
            • routing a chair seat JIm Widess, Sun Feb 26 3:41pm
              Thanks Kit. I appreciate the additional feedback - I was wondering if that Dremel bur would work. jim@caning.com
          • routing a chair seat DKR.SeatCaning, Thu Feb 23 7:56am
            Jim, although I have not received this yet, I ordered this bit to cut the groove in the chair. https://smile.amazon.com/gp/product/B00004UDIN/ref=od_aui_detailpages00?ie=UTF8&psc=1 Yesterday, I was... more
Click here to receive daily updates


Chair Caning Forum--The Caner's Community Hub™ 2004-2015