routing a chair seat
Wed Feb 22, 2017 11:20am

So Kit,
what Dremel bur would you use to cut the groove?

  • Dremel DKR.SeatCaning, Tue Feb 21 2:21pm
    Thanks, Kit, for your reply. I spent a couple days strategizing, and thought that using a Dremel would work. A regular router base was too wide, and the rotary tool that I have has a router base... more
    • routing a chair seat JIm Widess, Wed Feb 22 11:20am
      • Re: routing a chair seat Kit, Sat Feb 25 12:30pm
        Hi Jim, This is what I ordered from Amazon as what was in the Dremel kit didn't work. I used the largest bit. It worked for me as it was a narrow groove that I needed on a back.... more
        • routing a chair seat JIm Widess, Sun Feb 26 3:41pm
          Thanks Kit. I appreciate the additional feedback - I was wondering if that Dremel bur would work.
      • routing a chair seat DKR.SeatCaning, Thu Feb 23 7:56am
        Jim, although I have not received this yet, I ordered this bit to cut the groove in the chair. Yesterday, I was... more
Click here to receive daily updates

Chair Caning Forum--The Caner's Community Hub™ 2004-2015