Chair Caning Forum--The Caner's Community Hub™ for Beginners, Hobbyists and Professionals, since 2004
Chair with unequal sides
Fri Jun 8, 2018 11:10am
73.26.122.69

Greetings all -
I'm about to begin a rushing rocking chair. Front is 20.5" back is 15" - a difference I expect and know how to compensate for.

However, the length of one side rail is 1/2" longer than the other. I guess it's attached at a slightly wider angle than the shorter one, since the front & back are parallel.

What tips do you have for squaring up that difference? I can visualize unwrapping the rush a bit on the longer edge, but not sure how to square up the center and how to keep the strands parallel with those coming from the shorter edge.

Hope you can picture this.

(I detected the difference because I decided to put progress marks on the rails (every couple of inches from each corner) since the chair is big for me to work with - and I'd like to watch my spacing as I work, in addition to checking every 4 strands or so. Perhaps I should be measuring the sides in all my rush work?!)

Thanks for any guidance.

Laurie Schatzberg
Albuquerque, NM
Intermittently weaving seats since June 2012
http://TheCaningRoom.wordpress.com



    • Rush with unequal sides Back Porch Caning - Joyce Curtis, Sun Jun 10 5:43am
      I once came across a little rush chair with the front rail an inch and a half longer but the same number of strands front and back. The rows on the back rail were pressed tighter together and the... more
    • Re: Chair with unequal sides The Wicker Woman®--Cathryn, Sat Jun 9 7:21am
      Laurie, Happily, I've not had this experience in all my 40+ years as a seatweaver, so not sure if it will work or not but could you try to put in a few "short rows" on the front and back of that long ... more
      • Re: Chair with unequal sides ABQLaurie, Sun Jun 10 11:12am
        Thanks, Cathryn Just last night I started thinking along those lines and with your encouragement I’ll give it a try. I decided to use fibre rush instead of PTNR on this, too. Customer was... more
      • Unequal sides jwoods.enterprises, Sun Jun 10 8:20am
        I posted earlier but it must not have gone through. I have seen this many times. What I do is mark progression marks on the side rails but instead of measurement increments I divide proportionately.... more
        • Re: Unequal sides Cathryn Peters, Sun Jun 10 8:24am
          Sorry Jill, but I'm not following you at all here. How does taking adequate measurements account for one side rail being 1/2" longer than the other and filling in the difference accordingly? What am... more
          • Unequal sides jwoods.enterprises, Mon Jun 11 5:10am
            Once again, I answered you yesterday Cathryn but it Std not go through. Must be doing something wrong. You are correct though. My suggestion of progression marks by proportion spreads the need to... more
          • Re: Unequal sides ABQLaurie, Sun Jun 10 11:57pm
            Thanks all. Good approaches to try. Cathryn, I believe Jill’s method would aim to make up for the 1/2” in small increments. Perhaps a tiny fraction of an Inch for each segment of the weave. So if one ... more
      • Re: Chair with unequal sides The Wicker Woman®--Cathryn, Sat Jun 9 7:27am
        Laurie, Another solution might be to just wrap a few times around the front and back of that long rail, tacking on your start and stop, to compensate for the 1/2". But then it might leave a gap... more
  • Click here to receive daily updates


    Chair Caning Forum--The Caner's Community Hub™ 2004-2018