Chair Caning Forum--The Caner's Community Hub™ for Beginners, Hobbyists and Professionals, since 2004
Re: Unequal sides
Sun Jun 10, 2018 11:57pm
73.26.122.69

Thanks all. Good approaches to try.

Cathryn,
I believe Jill’s method would aim to make up for the 1/2” in small increments. Perhaps a tiny fraction of an Inch for each segment of the weave.

So if one rail were say 16” and the other 16.5, I could pencil-mark every 4” on the short side and 4.125 on the long side. Then I’d try to weave strands more compactly on the short side (and/or untwisted bit on the long side) to make up 0.125” on each of the 4 segments.

At least that’s what I visualize. :-)


  • Re: Unequal sides Cathryn Peters, Sun Jun 10 8:24am
    Sorry Jill, but I'm not following you at all here. How does taking adequate measurements account for one side rail being 1/2" longer than the other and filling in the difference accordingly? What am... more
    • Unequal sides jwoods.enterprises, Mon Jun 11 5:10am
      Once again, I answered you yesterday Cathryn but it Std not go through. Must be doing something wrong. You are correct though. My suggestion of progression marks by proportion spreads the need to... more
    • Re: Unequal sides ABQLaurie, Sun Jun 10 11:57pm
Click here to receive daily updates


Chair Caning Forum--The Caner's Community Hub™ 2004-2018